Related Experiment Video
Updated: Aug 16, 2025

Using a Virtual Reality Walking Simulator to Investigate Pedestrian Behavior
Published on: June 9, 2020
Learning to Cycle: Is Velocity a Control Parameter for Children's Cycle Patterns on the Balance Bike?
Cristiana Mercê1,2, Rita Cordovil1, David Catela2,3
1Centro Interdisciplinar de Estudo da Performance Humana, CIPER, Faculdade do Motricidade Humana, Universidade de Lisboa, 1499-002 Cruz-Quebrada, Portugal.
Abstract:
The balance bike (BB) has been pointed out as being the most efficient learning bicycle due to its inherent stimulation of balance. However, the process of acquiring the control of balance on the BB has not been explored. This study aimed to: (i) categorize the cycle patterns of children on the BB, (ii) compare the cycle patterns in different stages of learning (before and after six sessions of a BB practice program), and (iii) verify whether velocity is a control parameter leading to transitions between different cycle patterns on a BB. The data were collected during the Learning to Cycle program from 12 children aged 6.06 ± 1.25 years. The velocity was measured using an inertial sensor. Seven different movement patterns were captured and categorized through video analysis. After practice, there was an increase in the mean number of different patterns and in the global mean and maximum velocity. These were interpreted as an improvement of the motor competence in the use of the BB. The results obtained support the hypothesis that velocity is a control parameter which leads to the emergence of diverse patterns of behavior. As the speed increased, the amount of foot contact with the ground became less frequent and the locomotor modes that imply that longer flight phases began to emerge.
Related Concept Videos
Relative Motion Analysis - Velocity
When an external force is exerted, it sets the crank into a rotational movement. This, in turn, instigates the motion of the connecting rod, leading to what is referred to as a general plane motion. This process involves two key points - point A on the connecting rod...
Average and Instantaneous Velocity Vectors
Instantaneous Center of Zero Velocity
To analyze this, consider two points on the wheel: point A and point B. The absolute velocity of point B can be expressed as the vector sum of the absolute velocity of point A and the relative velocity of point B with respect to point A. To simplify this analysis,...
Velocity and Position by Graphical Method
Design Example: Designing Water Slide
Bernoulli's principle determines the water's velocity along the...
Relative Motion Analysis - Acceleration

