Collagen and Keratin Hydrolysates to Delay the Setting of Gypsum Plaster

Leather and wool waste represent a high concern due to the low level of valorization and circular economy demands for upcycling of biomass resources. Both biomasses can be easily processed as protein hydrolysates and used as functional additives due to the amphiphilic and tunable properties of collagen and keratin proteins. The chemical, physical, and structural investigations of collagen and keratin hydrolysate properties showed that the chelating abilities due to carboxylic groups can be exploited for gypsum retardant additives. The molecular weights and amino acid compositions of three different hydrolysates showed only slight influences on the setting time of gypsum; all three proteins delayed the setting time of gypsum between 60 and 120 min, as compared to the commercial plaster with a 30 min setting time. Higher molecular weight and more carboxylic active groups showed slight improvements in the setting time of mortars. The improved properties of keratin hydrolysate as compared to low molecular collagen hydrolysate were attributed to foaming and conductive properties. The mechanism of mortar setting delaying through calcium ions complexation by protein hydrolysates was shown by electric conductivity evolution of plasters with and without protein additives over time, supported by foaming properties, amino acid, and functional groups' composition. Lower bending strength values for the higher concentration of proteins do not reduce the potential to use the protein hydrolysates as retardant additives in mortar fabrication.