Flexural Strengthening of Large-Scale RC Beams with Nonprestressed and Prestressed CFRP Using Different Anchorages

Externally bonded carbon-fiber-reinforced polymer (CFRP) technology can be used by different methods based on the anchorage device, CFRP type, and prestressing/nonprestressing. However, a direct comparison between the strengthening efficacies of different methods is still lacking. Seven large-scale RC beams were tested in this study to investigate the influences of the anchorage method, CFRP type, prestress, and prestressing system on the flexural strengthening efficacy of RC beams. The test results showed that the ultimate load increased by 38.3%, whereas the cracking and yielding loads were slightly affected when the anchorage method was enhanced from CFRP U-wraps to wedge-clamp anchors. The CFRP plate and CFRP sheet could provide a rather close flexural strengthening efficacy under the same CFRP strengthening amount. Compared to the nonprestressed CFRP plate, the prestressed CFRP plate was highly superior in improving the flexural behavior of RC beams. The cracking, yielding, and ultimate loads of the prestressed CFRP-strengthened specimens were 57.1%, 22.9%, and 5.9%, respectively, higher than those of the nonprestressed CFRP-strengthened specimen with an effective anchorage. The two types of prestressing systems based on the adhesive-friction anchor and wedge-clamp anchor were proven to be effective for flexural strengthening of RC beams with prestressed CFRP plates, and they could provide almost the same strengthening effect.