Related Experiment Video
Updated: Aug 16, 2025

Determining Viral Disinfection Efficacy of Hot Water Laundering
Published on: June 21, 2022
Correlating the physico-chemical properties of two conventional glazed porcelain stoneware tiles in relation to
Erika Iveth Cedillo-González1,2, Paolo Chierici3, Marta Buttazzo4
1Department of Engineering "Enzo Ferrari", University of Modena and Reggio Emilia, Via P. Vivarelli 10/1, Modena 41125, Italy.
Abstract:
Keeping surfaces clean can reduce the spread of infections. In particular, to decrease the potential for SARS CoV-2 contamination, performing disinfection of high-touching surfaces. Several ceramic tiles and porcelain stoneware tiles with antimicrobial properties are already available on the market. However, the widespread use of antimicrobial glazed stoneware tiles may require to replace the ceramic surfaces already present in many buildings. The unfeasibility of such replacement can be due to both product durability (lifetime of a tile is usually long) and/or monetary restrictions. Furthermore, as porcelain stoneware per se does not have antimicrobial activity, these materials are fabricated by adding chemical agents able to provide antimicrobial properties. This approach requires a compatibility between the antimicrobial agents and the glaze formulation, as well as a careful control of the firing cycle and the final properties of the ceramic products. It follows that the final cost of antimicrobial tiles is not competitive with that of conventional tiles. In the latter, the persistence of potential pathogens on the surfaces is a crucial problem to face: the longer a pathogen survives on a surface, the longer it may be a source of transmission and thus endanger susceptible subjects. In this work, bacteria's capacity to adhere and to be effectively removed from two conventional glazed porcelain stoneware tiles (under dirty and clean conditions) was investigated. Two different glazes were tested, one mainly glassy (glossy) and the other mainly crystalline (matt). The sanitization procedures were carried out by chemical and chemo-mechanical procedures. The results showed that chemo-mechanical sanitization was the most effective, and the best results could be obtained on the stoneware tiles coated with the mainly glassy glaze, with the lowest porosity and the lower roughness values and water contact angles, especially under clean conditions.
Related Concept Videos
Cleaning, Sterilization, and Disinfection
Cleaning
The cleaning process usually involves using water with detergents or enzymatic cleaner and removing foreign material from objects and surfaces, including organic material such as body fluids or inorganic material like soil. Cleaning is performed before high-level disinfection and sterilization because foreign materials on the cover of the devices interfere with process...
Methods of Sterilization I: Physical Methods
Steam sterilization uses non-toxic, low-cost moist heat in the form of saturated steam under pressure, which is fast, microbicidal, and sporicidal, and quickly warms and penetrates fabrics. Autoclaves, or steam sterilizers, expose each item to direct steam contact for a predetermined time at the necessary...
Hand hygiene
Hand washing...
Methods of Sterilization II: Chemical Methods
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...
Handwashing II: Pre-procedure and Initial Procedure Steps
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury. The nails must be short and clean, without nail...
Mortar Properties

