Related Experiment Video
Updated: Aug 15, 2025
Author Spotlight: Three-Dimensional Cephalometric Landmark Annotation Demonstration on Human Cone Beam Computed Tomography Scans
Published on: September 8, 2023
The Correlation Between Morphologic Characteristics of Condyle and Glenoid Fossa with Different Sagittal Patterns of
Navid Kariminasab1, Zahra Dalili Kajan2, Arefeh Hajian-Tilaki3
1Department of Orthodontics, Faculty of Dentistry, Guilan University of Medical Sciences, Rasht, Iran.
Objective:
This study aimed to determine the relationship between the morphologic characteristics of condyle and glenoid fossa in different sagittal skeletal patterns using cone-beam computed tomography.
Methods:
In this cross-sectional study, the lateral cephalometric and cone-beam computed tomography images of 90 patients were evaluated. The patients were categorized into three equal groups of sagittal skeletal patterns, according to the ANB angle. The greatest anteroposterior and mediolateral diameters of the mandibular condyles, as well as the angle between the long axis of the mandibular condyles and the midsagittal plane, were measured on the axial view of cone-beam computed tomography images. The anterior joint space, superior joint space, posterior joint space, articular eminence inclination, depth of the glenoid fossa, and width of the glenoid fossa were also measured on the central sagittal slices. One-way analysis of variance (ANOVA), Tukey's post hoc test and chi-square test were performed.
Results:
Patients with the skeletal Class III had a significantly higher articular eminence inclination, while Class II patients had a lower articular eminence inclination (P = .001). In Class III patients, the depth of the glenoid fossa was greater, and the width of the glenoid fossa was smaller than in the other groups (P < .01). The anterior and posterior joint space did not show any significant differences between the 3 groups.
Conclusion:
There were significant differences in some morphological characteristics of the condyle and glenoid fossa in patients with different sagittal skeletal patterns; therefore, this relationship should be considered in the treatment of these patients.
Related Concept Videos
01:27Imaging Studies III: Computed Tomography
01:09Functional Classification of Joints
The functional classification of joints is determined by the amount of mobility between the adjacent bones. Joints are functionally classified as a synarthrosis or immobile joint, an amphiarthrosis or slightly moveable joint, or as a diarthrosis, a freely moveable joint. Fibrous and cartilaginous joints can be functionally classified as either synarthroses or amphiarthroses, whereas all synovial joints are classified as diarthroses.
Synarthrosis
An...
01:10Computed Tomography
The technique was invented in the 1970s and is based on the principle that as X-rays pass through the body, they are absorbed or reflected at different levels. In the technique, a patient lies on a motorized platform while a computerized axial tomography (CAT) scanner rotates...
01:27Cranial Bones: Lateral View
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
01:14Cranial Bones: Superior and Posterior View
The frontal bone is the single bone that forms the forehead. At its anterior midline, between the eyebrows, there is a slight depression called the glabella. The frontal bone also forms the supraorbital margin of the orbit. Near the middle of this margin is the supraorbital foramen, the opening that provides passage for a sensory nerve to the forehead. The frontal bone is thickened just above each supraorbital margin,...
01:26Bone Markings
Articulating Projections
Articulating projections are found where two bones meet to form a joint. These structures are usually found at the ends of bones. The largest articulation is a rounded projection called the head, supported by a narrow neck at the ends of...