Investigations into Determinants of Blueberry Coating Effectiveness

Coatings have been investigated as a means of slowing weight loss and helping to preserve quality in blueberries but reported results have been inconsistent with the inadequate presentation of the impact of coatings on blueberry appearance. In this study, we compare the ability to limit weight loss, along with the effect on appearance, of several previously studied coatings for blueberries and attempt to identify reasons why coatings have not been more successful in limiting weight loss in blueberries. In a two-year study, coatings were applied either as a spray or a dip, depending on the nature of the coating, and included 1% chitosan (CH) with and without either 1% or 2% oleic acid (OA), 1% Semperfresh (SF), 2% sodium caseinate (SC), and carnauba wax (CAR). None of the coatings reduced weight loss in either year of the study and sometimes enhanced it. CH, CH + OA, CAR, and SF greatly altered the appearance of the berries by removing all or a part of the waxy bloom. SC also did this to some degree but was generally better at maintaining the natural appearance. It was found that coating application did not effectively limit weight loss through either the cuticle or stem end of the blueberries. Loss of the bloom on the blueberry surface, confirmed visually and by scanning electron microscopy, occurred during coating application, but was found to not influence coating effectiveness. Using CH + OA as an example, it was found that increasing the amount of handling during the drying process significantly increased subsequent weight loss relative to blueberries with minimal handling. This indicates that careful handling during the coating process is important for coating success.