Optimization of Three Key Geometries of a Steam Ejector under Varied Primary Nozzle Geometries

In this paper, three key geometrical dimensions such as XL3 (constant pressure mixing chamber length), D5 (diameter of the throat of the ejector), and XL5 (length of the throat of the ejector) were separately or sequentially optimized under different lengths and angles of two sections of the primary nozzle. Furthermore, shock cluster number and shock chain length or area of low static pressure zone were used to analyze the effect of geometries on ejector performance, which is normally indicated by entrainment ratio (ER, or the ratio between the mass flow rate of secondary flow and the mass flow rate of primary flow). The results show that: (1) the improvement of ejector performance with only optimization of the primary nozzle is quite limited, in comparison, the impact of length and angle of nozzle diverging section on ejector performance is higher than that of converging section; (2) the relative sensitivity of ER to three key dimensions is much higher than that to the angles and lengths of the primary nozzle; (3) with the increase of XL3 and D5, ER needs a larger angle and smaller length of nozzle converging section; (4) the impact of key geometries on ejector performance can be analyzed with the help of shock cluster number and shock chain length or area of low static pressure zone.