Related Experiment Video
Updated: Aug 13, 2025

Fabrication of Gate-tunable Graphene Devices for Scanning Tunneling Microscopy Studies with Coulomb Impurities
Published on: July 24, 2015
Dual-mode frequency multiplier in graphene-base hot electron transistor
Bor-Wei Liang1, Min-Fang Li1, Hung-Yu Lin1
1Graduate Institute of Electronics Engineering, National Taiwan University, Taipei 10617, Taiwan.
Abstract:
Since quantum computers have been gradually introduced in countries around the world, the development of the many related quantum components that can operate independently of temperature has become more important for enabling mature products with low power dissipation and high efficiency. As an alternative to studying cryo-CMOSs (complementary metal-oxide-semiconductors) to achieve this goal, quantum tunneling devices based on 2D materials can be examined instead. In this work, a vertical graphene-based quantum tunneling transistor has been used as a frequency modulator. The transistor can operate via different quantum tunneling mechanisms and generates, by applying the appropriate bias, voltage-resistance curves characteristic of variable nonlinear resistance for both base and emitter voltages. We experimentally demonstrate frequency modulation from input signals over the range of 100 kHz to 10 MHz, enabling a tunable frequency doubler or tripler in just a single transistor. This frequency multiplication with a tunneling mechanism makes the graphene-based tunneling device a promising option for frequency electronics in the emerging field of quantum technologies.
Related Concept Videos
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...
MOSFET: Depletion Mode
The primary characteristic of depletion-mode MOSFETs is their ability to conduct current between the drain and source terminals without gate bias. This inherent conductivity...
Design Example: Capacitance Multiplier Circuit
The circuit illustrated in Figure 1 below incorporates two op-amps, with the first operating as a voltage follower and the second acting as an inverting amplifier.
Biasing of FET
In an N-channel JFET, the structure consists of N-type material forming the channel on a P-type substrate, with the...
Cut-off Frequency of BJT
Alpha Cut-Off Frequency: Pertinent to the common-base configuration, the alpha cut-off frequency defines the upper-frequency limit at which the current gain, alpha, remains stable. As...
MOSFET Amplifiers

