Abrasive Enamel and Dentin Wear Resulting from Brushing with Toothpastes with Highly Discrepant Relative Enamel...

To investigate the absolute wear caused by toothpastes with highly discrepant REA (Relative Enamel Abrasivity) and RDA (Relative Dentin Abrasivity) values on both enamel and dentin: Candida Peppermint (CP; REA: 1; RDA: 42), Colgate Total Original (CTO; REA: 4; RDA: 100), Signal White System (SWS; REA: 8; RDA: 143), and Candida White Diamond (CWD; REA 244; RDA: 12).

Eighty (80) bovine enamel samples and 80 dentin samples were divided into four groups each (n = 20) and investigated after a 6-h brushing procedure (21,600 cycles, 60 cycles/min, load of 2.5 N) with the four toothpastes. The abrasive enamel and dentin wear were registered using a contact profilometer. The median and interquartile range (IQR) of the abrasive enamel and dentin wear were calculated for each group. Pairwise comparisons were conducted using the Wilcoxon signed-rank exact test, and the p-value was adjusted according to Holm (statistical significance set at 0.05).

CWD led to the highest abrasive enamel wear (9.86 μm [5.77]). CTO caused the highest abrasive dentin wear (166.70 μm [69.90]), being statistically significantly higher than the wear for CP (54.20 μm [24.00]) and CWD (17.00 μm [7.80]) (p = 0.00001). The abrasive dentin wear for CWD was statistically significantly lower in comparison to all other groups (p = 0.00001).

Toothpastes with highly discrepant REA and RDA values presented statistically significantly different absolute wear on enamel and dentin. REA and RDA values should both be declared for every toothpaste.