Application of post-column reaction gas chromatography with a single reference gas for offshore air and gas seeped...

Ambient air commonly contains carbon dioxide at concentrations greater than 400 µmol mol^-1 and methane at ~ 2000 nmol mol^-1; non-methane hydrocarbons are also widespread in the atmosphere at much lower concentrations. For quantification of various carbon-containing compounds in typical analytical instrument, corresponding number of reference materials are required. Therefore, the development of a method that uses a single reference material applicable to air monitoring is desired. Here, we examined a post-column reaction system combined with a gas chromatograph equipped with a flame ionization detector (FID), which involves oxidation and reduction processes after separation. To determine various carbon-containing gases by post-column reaction gas chromatography with FID (GC-r-FID) using a single reference, it is necessary to confirm a good linearity of the response with carbon concentrations originating from various carbon-containing gases. When mixtures of carbon-containing gases at three different concentrations and the calibration curve of the FID response with the concentration converted into methane were used, a single linear calibration curve (correlation coefficient > 0.9999, 18 points) was obtained over four orders of magnitudes (to ~ 5000 µmol mol^-1 as methane). The applicability of GC-r-FID was confirmed by determining carbon-containing gases in air and gas seeped from the seafloor samples. Because the results were comparable to those obtained by conventional GC-FID and GC-thermal conductivity detector, typically GC-r-FID with a single reference gas should be suitable for air monitoring.