Related Experiment Video

Updated: Aug 9, 2025

Bringing the Visible Universe into Focus with Robo-AO
10:35

Bringing the Visible Universe into Focus with Robo-AO

Published on: February 12, 2013

19.5K

Analysis and correction of misalignment-induced aberrations in two-mirror telescopes with stop on the secondary

Yang Wang, Yingrui Li, Zhiyuan Gu

    Applied Optics
    |February 23, 2023
    PubMed

    More Related Videos

    A Guide to Structured Illumination TIRF Microscopy at High Speed with Multiple Colors11:15

    A Guide to Structured Illumination TIRF Microscopy at High Speed with Multiple Colors

    Published on: May 30, 2016

    25.3K
    The Generation of Higher-order Laguerre-Gauss Optical Beams for High-precision Interferometry12:14

    The Generation of Higher-order Laguerre-Gauss Optical Beams for High-precision Interferometry

    Published on: August 12, 2013

    21.9K

    Related Concept Videos

    Adjusting a Traverse01:12

    Adjusting a Traverse

    In the site survey of a four-sided traverse, internal angles are essential to ensure geometric accuracy. The survey revealed that the sum of the measured internal angles was 359 degrees and 48 minutes, which is 12 minutes less than the expected 360 degrees. This discrepancy signals an error likely arising from measurement inaccuracies during the fieldwork.To rectify this error, the adjustment process involved distributing the 12-minute shortfall equally across the four internal angles. By...
    91
    Common Leveling Mistakes and Errors01:17

    Common Leveling Mistakes and Errors

    A survey team is tasked with determining the elevation difference between points Point A and Point B, separated by uneven terrain. They use a leveling instrument and a leveling rod.Common MistakesMisreading the Rod: During a backsight reading at Point A, the instrumentman observes the rod partially obscured by tall grass. Instead of reading 1.135 m, they mistakenly record 1.735 m due to the misalignment of the crosshair with the wrong graduation. This error adds 0.600 m to all subsequent...
    105
    Errors in Taping01:18

    Errors in Taping

    Errors in taping arise from multiple factors that can significantly impact measurement accuracy in surveying. Misalignment of the tape, often due to human error, is one primary source. A skilled rear tapeman, using a telescope, can help correct alignment by guiding the head tapeman; however, human limitations still lead to small inaccuracies. These errors may include misplacement of pins or inaccurate tape readings due to common visual confusions, such as mistaking a six for a nine. Such...
    60
    Distance Corrections01:15

    Distance Corrections

    To achieve precise distance measurements, especially in surveying and construction, certain corrections must be applied to account for potential sources of error like the standardization errors, temperature variations, and slope adjustments.Standardization error emerges when measurement equipment undergoes changes, such as wear, repairs, or weather impacts. To address this, surveyors compare the equipment’s readings to a standard. This process identifies any deviation that might lead to...
    59