Related Experiment Video
Updated: Aug 8, 2025

A Photonic System for Generating Unconditional Polarization-Entangled Photons Based on Multiple Quantum Interference
Published on: September 5, 2019
Performance Analysis of Turbo Codes, LDPC Codes, and Polar Codes over an AWGN Channel in the Presence of Inter Symbol
Adriana-Maria Cuc1, Florin Lucian Morgoș1, Cristian Grava1
1Department of Electronics and Telecommunications, University of Oradea, 410087 Oradea, Romania.
Abstract:
This paper discusses the results of simulations relating to the performances of turbo codes, low density parity check (LDPC) codes, and polar codes over an additive white Gaussian noise (AWGN) channel in the presence of inter symbol interference, denoting the disturbances that altered the original signal. To eliminate the negative effects of inter symbol interference (ISI), an equalizer was used at the level of the receiver. Practically, two types of equalizers were used: zero forcing (ZF) and minimum mean square error (MMSE), considering the case of perfect channel estimation and the case of estimation using the least square algorithm. The performance measure used was the modification of the bit error rate compared to a given signal to noise ratio; in this sense, the MMSE equalizer offered a higher performance than the ZF equalizer. The aspect of channel equalization considered here is not novel, but there have been very few works that dealt with equalization in the context of the use of turbo codes, especially LDPC codes and polar codes for channel coding. In this respect, this research can be considered a contribution to the field of digital communications.
More Related Videos
14:18Automation of Mode Locking in a Nonlinear Polarization Rotation Fiber Laser through Output Polarization Measurements
Published on: February 28, 2016
09:01Gain-compensation Methodology for a Sinusoidal Scan of a Galvanometer Mirror in Proportional-Integral-Differential Control Using Pre-emphasis Techniques
Published on: April 4, 2017
Related Concept Videos
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be...
Receiver Operating Characteristic Plot
Linear Approximation in Time Domain
For a simple pendulum with a mass evenly distributed along its length and the center of mass located at half the pendulum's length,...
Time-Domain Interpretation of PD Control
Consider the example of control of motor torque. Initially, a positive...
Basic Discrete Time Signals
The unit impulse or sample sequence is mathematically expressed as zero for all n values except at n=0, where it is one. The unit impulse sequence, denoted by δ(n), is the first difference of the unit step sequence, while the unit step sequence u(n) is...
Frequency-Domain Interpretation of PD Control
The proportional control gain, combined with the...