Related Experiment Video
Updated: Aug 7, 2025

Reducing Willow Wood Fuel Emission by Low Temperature Microwave Assisted Hydrothermal Carbonization
Published on: May 19, 2019
Toward a Hydrogen-Free Reductive Catalytic Fractionation of Wheat Straw Biomass
Filippo Brienza1,2, Korneel Van Aelst3, François Devred2
1Applied Microbiology Division, Earth and Life Institute (ELI), UCLouvain, Croix du Sud 2, 1348, Louvain-La-Neuve, Belgium.
Abstract:
The reductive catalytic fractionation (RCF) of lignocellulosic biomass is an attractive method for the conversion of lignin toward valuable low-molecular weight aromatics. A limitation to the upscaling of such technology is represented by the use ofpressurized hydrogen gas. Here, the role of hydrogen gas within the RCF of wheat straw biomass is investigated. The use of H2 is shown to enhance lignin depolymerization, by virtue of an improved hydrogenolysis and hydrogenation of lignin fragments, with a yield of phenolic monomers that increased from ca. 12 wt % of acid-insoluble lignin in the initial biomass under inert atmosphere to up to ca. 25 wt % under H2 (in methanol, at 250 °C, with Ru/C). The adoption of methanol, ethanol or isopropanol as hydrogen-donor solvents was also investigated in the absence of H2 . Ethanol was found to give the highest yield of monophenolic compounds (up to ≈20 wt %) owing to a better balance between solvolysis, hydrogenolysis, and hydrogenation of lignin. Nevertheless, a substantial loss of the carbohydrate fraction was observed. The use of a lower temperature (200 °C) in combination with H3 PO4 resulted in an improved recovery of cellulose in the pulp and in the solubilization of hemicellulose and lignin, with the formation of monosaccharides (≈14 wt % of polysaccharides in the initial biomass) and phenolic monomers (up to 18 wt %, in the absence of H2 ). Overall, a tradeoff exists between the removal of H2 from the process and the production of low-molecular weight phenolics during RCF.
Related Concept Videos
Reduction of Alkenes: Asymmetric Catalytic Hydrogenation
The metal catalyst used can be either heterogeneous or homogeneous. When hydrogenation of an alkene generates a chiral center, a pair of enantiomeric products is expected to form. However, an enantiomeric excess of one of the products can be facilitated using an enantioselective reaction or an...
Reduction of Alkenes: Catalytic Hydrogenation
Metals like palladium, platinum, and nickel are commonly used in their solid forms — fine powder on an inert surface. As these catalysts remain insoluble in the reaction mixture, they are referred to as heterogeneous catalysts.
The hydrogenation process takes place on the...
Reduction of Alkynes to cis-Alkenes: Catalytic Hydrogenation
Like alkenes, alkynes can be reduced to alkanes in the presence of transition metal catalysts such as Pt, Pd, or Ni. The reaction involves two sequential syn additions of hydrogen via a cis-alkene intermediate.
Reduction of Benzene to Cyclohexane: Catalytic Hydrogenation
Aldehydes and Ketones to Alkanes: Wolff–Kishner Reduction
Alcohols from Carbonyl Compounds: Reduction
Catalytic hydrogenation is similar to the reduction of an alkene or alkyne by adding H2 across the pi bond in the presence of transition metal catalysts like Raney Ni, Pd–C, Pt, or Ru. Aldehydes and ketones can be reduced by this method, often under mild to moderate heat (25–100°C) and...

