Study of solid loading of feedstock using trimodal iron powders for extrusion based additive manufacturing

Volume loading of feedstock using trimodal iron (Fe) powders was investigated for the application of extrusion-based additive manufacturing (AM). Fe trimodal powder composed of nano, sub-nano, and micro particles was manufactured via the powder metallurgy process where small particles behave as rolling bearings among large particles, and thereby improving the flow characteristics of feedstock by minimizing friction among the particles. The flow behavior and microstructures of the monomodal feedstock were compared with those of the trimodal feedstock. We have confirmed that the critical powder loading of monomodal powder was measured to be 70 vol.% while trimodal powder showed up to 74 vol.%. Furthermore, trimodal feedstocks of 60, 65, 70, 75, and 80 vol.% Fe powder were prepared to determine the optimal powder content for sintering. As a result, the feedstock with powder content of 70 vol.% gave the highest sintered density of 92.32%, the highest Vickers hardness of 80.67 HV, with the smallest dimensional variation in shrinkage, proposing 70 vol.% of trimodal feedstock to be the suitable powder content for AM. Finally, its microstructural and mechanical comparison with 70 vol.% sintered part using monomodal Fe powder, showed that the sintered part using trimodal feedstock displayed higher hardness, uniform shrinkage as well as smaller grain size, confirming trimodal feedstock to be favorable for the application of extrusion-based AM.