Related Experiment Video
Updated: Aug 5, 2025

A Minimally Invasive Model to Analyze Endochondral Fracture Healing in Mice Under Standardized Biomechanical Conditions
Published on: March 22, 2018
Ideal Length and Diameter for Intramedullary Screw Fixation of Metacarpal Fractures: A Biomechanical Study
Kent T Yamaguchi1, Scott Telfer1, Nicholas Iannuzzi1
1Department of Orthopaedics and Sports Medicine, University of Washington, Seattle, WA.
Purpose:
This biomechanical study evaluated the effect of intramedullary screw diameter and length relative to 3-point bending force and torsional force when used to stabilize metacarpal shaft fractures.
Methods:
Transverse osteotomies were made in the proximal metacarpal shaft in 36 middle finger metacarpal fourth-generation composite Sawbones. To compare screw diameters, antegrade intramedullary screws of 30-mm length were placed in 6 metacarpals, which included 4.7-mm Acutrak 2, Standard Acutrak 2 (4.0 mm), and Mini-Acutrak 2 (3.5 mm) screws. To compare screw lengths, metacarpals were fixated with Standard Acutrak 2 screws of 26, 30, or 34 mm in length, with screw tips bypassing the osteotomy by 6, 10, or 14 mm, respectively. A 6 degrees of freedom robot was used for torsional and 3-point bending testing.
Results:
Increasing screw diameter demonstrated significant differences in both 3-point bending and torsional strengths. Maximum torsional loads were 69 Ncm (4.7-mm Acutrak 2), 45 Ncm (Standard Acutrak 2), and 27 Ncm (Mini-Acutrak 2) (P < .05). Loads to failure in the 3-point bending tests were 916 N (4.7-mm Acutrak 2), 713 N (Standard Acutrak 2), and 284 N (Mini-Acutrak 2) (P < .05). Differing screw lengths demonstrated significant differences with maximum torsional loads when comparing the 26-mm screws (22 Ncm) with 30- and 34-mm screws (45 and 55 Ncm, respectively) (P < .05). The 3-point dorsal bending strengths were significantly different between the 26-mm screws (320 N) and 30- and 34-mm screws (713 N and 702 N, respectively) (P < .05).
Conclusions:
The results demonstrated significantly higher torsional strength and resistance to 3-point bending with larger intramedullary screw diameters. Further, when selecting the intramedullary screw length, the screw tip should pass at least 10 mm beyond the fracture.
Clinical Relevance:
This study provided biomechanical evidence to guide surgeons in selecting intramedullary screw diameter and length for treating metacarpal fractures.
More Related Videos
07:41An Intramedullary Locking Nail for Standardized Fixation of Femur Osteotomies to Analyze Normal and Defective Bone Healing in Mice
Published on: November 13, 2016
06:59Fracture Apparatus Design and Protocol Optimization for Closed-stabilized Fractures in Rodents
Published on: August 14, 2018