A Dual Triggering Scheme to Adaptive Fuzzy Resilient Control of Switched Nonlinear Systems Against Mixed Attacks
Abstract:
A dual event-triggered adaptive fuzzy resilient control scheme for a class of switched nonlinear systems with vanishing control gains under mixed attacks is proposed in this article. The scheme proposed achieves dual triggering in the channels of sensor-to-controller and controller-to-actuator by designing two new switching dynamic event-triggering mechanisms (ETMs). An adjustable positive lower bound of interevent times for each ETM is found to preclude Zeno behavior. Meanwhile, mixed attacks, that is, deception attacks on sampled state and controller data and dual random denial-of-service attacks on sampled switching signal data, are handled by constructing event-triggered adaptive fuzzy resilient controllers of subsystems. Compared with the existing works for switched systems with only single triggering, more complex asynchronous switching caused by dual triggering and mixed attacks and subsystem switching is addressed. Further, the obstacle caused by vanishing control gains at some points is eliminated by proposing an event-triggered state-dependent switching law and introducing vanishing control gains into a switching dynamic ETM. Finally, a mass-spring-damper system and a switched RLC circuit system are applied to verify the obtained result.
Related Concept Videos
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Reclosers and Fuses
A comprehensive protection scheme for radial distribution...
Multi-input and Multi-variable systems
In the absence...
Open and closed-loop control systems
An open-loop control system operates without feedback from the output. It consists of two primary elements: the controller and the controlled process. The controller receives an input signal...
Line Protection with Impedance Relays
Under normal conditions, low load currents keep the measured...
Controller Configurations
Control-system compensation involves various configurations, most commonly series or cascade compensation, in which the controller...


