Improving the Stability of Non-fullerene-Based Organic Photovoltaics through Sequential Deposition and Utilization of...

The development of organic photovoltaic (OPV) devices based on non-fullerene acceptors (NFAs) has led to a rapid improvement in their efficiency. Despite these improvements, significant performance degradation in the early stages of operation, known as burn-in, remains a challenge for NFA-based OPVs. To address this challenge, this study demonstrates a stable NFA-based OPV fabricated using sequential deposition (SqD) and a quasi-orthogonal solvent. The quasi-orthogonal solvent, which is prepared by incorporating 1-chloronaphthalene (1-CN) into dichloromethane (DCM), reduces the vapor pressure of the solvent and allows for the efficient dissolution and penetration of the Y6 (one of efficient NFAs) into a PM6 polymer-donor layer without damaging the latter. The resulting bulk heterojunction (BHJ) is characterized by a higher degree of crystallinity in the PM6 domains than that prepared using a conventional single-step deposition (SD) process. The OPV fabricated using the SqD process exhibits a PCE of 14.1% and demonstrates superior thermal stability to the SD-processed OPV. This study conclusively reveals that the formation of a thermally stable interface between the photoactive layer and the electron-transport layer (ETL) is the primary factor contributing to the high thermal stability observed in the SqD-processed OPV.