Related Experiment Video
Updated: Aug 2, 2025

Real-Time DC-dynamic Biasing Method for Switching Time Improvement in Severely Underdamped Fringing-field Electrostatic MEMS Actuators
Published on: August 15, 2014
Switching Anti-Windup Synthesis for Linear Systems With Asymmetric Actuator Saturation
Abstract:
This article proposes a switching anti-windup strategy for linear, time-invariant (LTI) systems subject to asymmetric actuator saturation and L2 -disturbances, the core idea behind which is to make full use of the available range of control input space by switching among multiple anti-windup gains. The asymmetrically saturated LTI system is converted to a switched system with symmetrically saturated subsystems, and a dwell time switching rule is presented to govern the switching between different antiwindup gains. Based on multiple Lyapunov functions, we derive sufficient conditions for guaranteeing the regional stability and weighted L2 performance of the closed-loop system. The switching anti-windup synthesis that designs a separate anti-windup gain for each subsystem is cast as a convex optimization problem. In comparison with the design of a single anti-windup gain, our method can induce less conservative results since the asymmetric character of the saturation constraint is fully utilized in the switching anti-windup design. Two numerical examples, and an application to aeroengine control (the experiments are conducted on a semiphysical test bench), demonstrate the superiority and practicality of the proposed scheme.
More Related Videos
Related Concept Videos
Linear Approximation in Time Domain
For a simple pendulum with a mass evenly distributed along its length and the center of mass located at half the pendulum's length,...
Second Order systems II
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be...
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Open and closed-loop control systems
An open-loop control system operates without feedback from the output. It consists of two primary elements: the controller and the controlled process. The controller receives an input signal...
Switching of BJT
Cut-off Mode ("Off" State): In this state, both the emitter-base and collector-base junctions are...

