A modified and rapid method for the single-well push-pull (SWPP) test using SF₆, Kr, and uranine tracers

In the present study, a single-well push-pull (SWPP) test was conducted with multi-component tracers, including inert gas (SF₆ and Kr) and uranine (conservative), to understand the volatile/semi-volatile component transport characteristics in the groundwater system. In an SWPP test, it is essential to obtain an initial breakthrough curve (BTC) of the inert gas concentration at the beginning of the pulling stage to analyze the hydraulic properties of the groundwater system. As a result of the SWPP test using a proposed method in this study, physicochemical parameters of the groundwater and BTC of gas tracers and uranine were acquired simultaneously and successfully. In addition, on-site measurements of uranine, pCO₂, and water quality data, such as electrical conductivity (EC), temperature, pH, and dissolved oxygen, were undertaken. Modification of an existing pCO₂ measuring system allowed the gas samples to be collected, transported, and analyzed for inert gas components within a few hours. As a result, reliable and interpretable data with a recovery ratio of 26%, 85%, and 95% for SF_6, Kr, and uranine, respectively, were obtained. The differences in the recovery ratio were utilized to identify the environmental system, whether it contains gas inside the isolated system (closed) or not (open), and to understand plume behavior characteristics in the experimental zone. By applying a two-dimensional advection-dispersion model to the acquired tracer test data and comparing the observed and computed tracer concentrations, helpful information was obtained on the hydraulic and transport characteristics of the targeted zone. This method can be extended to the design of dissolved CO₂ transport monitoring of an aquifer above a CCS site.