Related Experiment Video
Updated: Jul 30, 2025

Experimental Protocol to Investigate Particle Aerosolization of a Product Under Abrasion and Under Environmental Weathering
Published on: September 16, 2016
Experimental Study on Humidification Coagulation and Removal of Fine Particles Using an Electrostatic Precipitator
Lichun Xiao1, Xiaoyu Zhai1, Yingying Han1
1Hebei Key Laboratory of Heavy Metal Deep-Remediation in Water and Resource Reuse, School of Environmental and Chemical Engineering, Yanshan University, Qinhuangdao 066004, China.
Abstract:
A wet electrostatic precipitator (WESP) has much higher capture rate for fine particulate matter, PM2.5, than a traditional dry type electrostatic precipitator does. In order to make full use of existing dust removal equipment and reduce the emissions of smoke and dust to zero, a combination of chemical coagulation and humidification coagulation is proposed using a WESP. The results show that the addition of chemical coagulant can promote the coagulation of coal-fired dust particles. After the addition of pectin (PG), the median diameter of dust particles increases from 28.19 μm to 45.28 μm. Water vapor humidification can promote the coagulation of dust particles. When the water vapor injection rate increases from 0 kg/h to 3.2 kg/h, the median diameter of dust particles increases from 28.19 μm to 36.45 μm. The synergistic effect of the coagulant and water vapor can enhance the chemical coagulation effect; when 1.0 × 10-2 g/L PG and 3.2 kg/h water vapor synergize, the collection efficiency reaches 98.17%, and when 1.0 × 10-2 g/L polyacrylamide (PAM) and 3.2 kg/h water vapor synergize, the collection efficiency reaches 96.68%. Both chemical coagulation and water vapor humidification can promote the condensation of coal dust, which is beneficial to improve the efficient capture of fine particles using WESP.
Related Concept Videos
Precipitation and Co-precipitation
Colloidal precipitates
Coagulation
Preparation of Samples for Electron Microscopy
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
Washing, Drying, and Ignition of Precipitates

