Plasma Protein Binding Evaluations of Per- and Polyfluoroalkyl Substances for Category-Based Toxicokinetic Assessment
Marci Smeltz1, John F Wambaugh1, Barbara A Wetmore1
1Center for Computational Toxicology and Exposure, US EPA Office of Research and Development, Research Triangle Park, North Carolina 27711, United States.
Abstract:
New approach methodologies (NAMs) that make use of in vitro screening and in silico approaches to inform chemical evaluations rely on in vitro toxicokinetic (TK) data to translate in vitro bioactive concentrations to exposure metrics reflective of administered dose. With 1364 per- and polyfluoroalkyl substances (PFAS) identified as of interest under Section 8 of the U.S. Toxic Substances Control Act (TSCA) and concern over the lack of knowledge regarding environmental persistence, human health, and ecological effects, the utility of NAMs to understand potential toxicities and toxicokinetics across these data-poor compounds is being evaluated. To address the TK data deficiency, 71 PFAS selected to span a wide range of functional groups and physico-chemical properties were evaluated for in vitro human plasma protein binding (PPB) by ultracentrifugation with liquid chromatography-mass spectrometry analysis. For the 67 PFAS successfully evaluated by ultracentrifugation, fraction unbound in plasma (fup) ranged from less than 0.0001 (pentadecafluorooctanoyl chloride) to 0.7302 (tetrafluorosuccinic acid), with over half of the PFAS showing PPB exceeding 99.5% (fup < 0.005). Category-based evaluations revealed that perfluoroalkanoyl chlorides and perfluorinated carboxylates (PFCAs) with 6-10 carbons were the highest bound, with similar median values for alkyl, ether, and polyether PFCAs. Interestingly, binding was lower for the PFCAs with a carbon chain length of ≥11. Lower binding also was noted for fluorotelomer carboxylic acids when compared to their carbon-equivalent perfluoroalkyl acids. Comparisons of the fup value derived using two PPB methods, ultracentrifugation or rapid equilibrium dialysis (RED), revealed RED failure for a subset of PFAS of high mass and/or predicted octanol-water partition coefficients exceeding 4 due to failure to achieve equilibrium. Bayesian modeling was used to provide uncertainty bounds around fup point estimates for incorporation into TK modeling. This PFAS PPB evaluation and grouping exercise across 67 structures greatly expand our current knowledge and will aid in PFAS NAM development.
More Related Videos
07:06Investigating Long-Distance Transport of Perfluoroalkyl Acids in Wheat via a Split-Root Exposure Technique
Published on: September 28, 2022
05:47In Silico Modeling Method for Computational Aquatic Toxicology of Endocrine Disruptors: A Software-Based Approach Using QSAR Toolbox
Published on: August 28, 2019
Related Concept Videos
Drug Distribution: Plasma Protein Binding
Physiological Pharmacokinetic Models: Assumption with Protein Binding
Factors Affecting Protein-Drug Binding: Protein-Related Factors
The physicochemical properties of a drug play a significant role in its ability to bind to proteins. Lipophilic drugs, which dissolve in fats, oils, and lipids, can be...
Protein-Drug Binding: Determination Methods
Indirect methods involve isolating the bound drug from its free form in biological samples such as blood, serum, or plasma. These techniques aim to measure the percentage of drugs bound to proteins. Equilibrium dialysis is a commonly used method where the free drug concentration at equilibrium is measured by separating the bound...
Hepatic Drug Clearance: Effect of Protein Binding
For low-extraction-ratio drugs that are less than 80% protein-bound, minor changes in protein binding...
Nonlinear Pharmacokinetics: Bioavailability and Protein-Drug Binding
To quantify the extent of bioavailability, pharmacologists often use a parameter called .
