Related Experiment Video
Updated: Jul 26, 2025

Training Persons with Spinal Cord Injury to Ambulate Using a Powered Exoskeleton
Published on: June 16, 2016
Effects of the Auxivo CarrySuit occupational exoskeleton when carrying front and side loads on a treadmill
1Department of Electrical and Computer Engineering, University of Cincinnati, USA.
Abstract:
Low-cost exoskeletons can effectively support workers in physically demanding jobs, but most such exoskeletons have been developed to support repetitive lifting or uncomfortable static postures. Very few low-cost exoskeletons have been designed to support walking while carrying heavy objects, which would be beneficial for jobs such as moving furniture and warehouse work. This paper thus presents a single-session lab evaluation of the Auxivo CarrySuit, a low-cost upper-body exoskeleton designed for carrying objects that would normally be held with the arms. Twenty participants carried four loads (box or two bags, 20 or 40 lb total weight) for 2 min each on a treadmill with and without the CarrySuit. Across all loads, the CarrySuit significantly reduced the mean electromyogram of the middle trapezius (partial eta-squared = 0.74 - from 16.1% to 8.8% of maximum voluntary contraction value) and anterior deltoid (partial eta-squared = 0.26 - from 3.0% to 1.1% of maximum voluntary contraction value) with no corresponding increase in lower back muscle activation. Furthermore, maximum heart rate and Ratings of Perceived Exertion were also reduced by the CarrySuit, and discomfort was shifted from the upper body to the legs. While arm EMG was not measured, it is likely that it was also reduced due to the unloading of the arms. The CarrySuit can thus be considered beneficial in the short term, though longer-term evaluations with actual workers are needed to determine practical benefits.
More Related Videos
06:00A Rehabilitation Program of Exoskeleton-assisted Body Weight-Supported Treadmill Training with Non-immersive Virtual Reality for Stroke Patients
Published on: May 16, 2025
08:04Using a Split-belt Treadmill to Evaluate Generalization of Human Locomotor Adaptation
Published on: August 23, 2017
Related Concept Videos
Eccentric Loading
General Case of Eccentric Axial Loading
Consider a member subjected to equal and opposite forces that are applied along a line that does not coincide with the member's neutral axis. In unsymmetrical...
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Deformation of Member under Multiple Loadings
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
Cable Subjected to Concentrated Loads
Machines: Problem Solving II