Related Experiment Video
Updated: Jul 25, 2025

Heterogeneous Removal of Water-Soluble Ruthenium Olefin Metathesis Catalyst from Aqueous Media Via Host-Guest Interaction
Published on: August 23, 2018
Hydrogen sulfide removal from normal heptane using zinc oxide, silicon dioxide and zeolite 13X: adsorption capacity,
Mohammad Reza Zaeri1, Feridun Esmaeilzadeh2
1Department of Chemical and Petroleum Engineering, School of Chemical, Petroleum and Gas Engineering, Enhanced Oil and Gas Recovery Institute, Advanced Research Group for Gas Condensate Recovery, Shiraz University, Shiraz, 7134851154, Iran.
Abstract:
This article focuses on the H2S adsorption from normal heptane (nC7) as synthetic natural gas liquids (NGL) using ZnO, SiO2 and zeolite 13X in static mode. Results of the isotherm and kinetics of the investigated adsorbents for H2S adsorption under ambient condition showed that ZnO had the highest H2S adsorption capacity between 260 and 700 mgH2S.g-1 in the initial concentration range of 2500 and 7500 ppmH2S with an equilibrium time of less than 30 minutes. Additionally, the ZnO selectivity was greater than 3.16. In continued, H2S removal from nC7 with ZnO was examined in dynamic mode. The H2S breakthrough time for ZnO reduced from 210 to 25 minutes as weight hourly space velocity (WHSV) was increased from 5 to 20 h-1 at 30 bar. Also, the breakthrough time at 30 bar was about 2.5 times greater than that at atmospheric pressure. Furthermore, H2S/CO2 mixture (i.e., 1000 ppmH2S + 1000 ppmCO2) caused the H2S breakthrough time to increase approximately by 1.11-fold. Alternatively, the ZnO regeneration conditions with hot stagnant air were optimized at different initial H2S concentrations (1000 ~ 3000 ppmH2S) using the Box-Behnken design. For instance, ZnO contaminated with 1000 ppmH2S was regenerated with an efficiency of more than 98 % for 160 minutes at 285 °C.
Related Concept Videos
Reduction of Alkenes: Catalytic Hydrogenation
Metals like palladium, platinum, and nickel are commonly used in their solid forms — fine powder on an inert surface. As these catalysts remain insoluble in the reaction mixture, they are referred to as heterogeneous catalysts.
The hydrogenation process takes place on the...
Preparation and Reactions of Sulfides
Reduction of Benzene to Cyclohexane: Catalytic Hydrogenation
Reduction of Alkenes: Asymmetric Catalytic Hydrogenation
The metal catalyst used can be either heterogeneous or homogeneous. When hydrogenation of an alkene generates a chiral center, a pair of enantiomeric products is expected to form. However, an enantiomeric excess of one of the products can be facilitated using an enantioselective reaction or an...
Catalysis
Radical Substitution: Hydrogenolysis of Alkyl Halides with Tributyltin Hydride
The bonds formed in this reaction are stronger than the bonds broken, making it energetically favorable. The reaction follows a radical chain mechanism similar to radical halogenation...

