Related Experiment Video
Updated: Jul 25, 2025

Quasi-light Storage for Optical Data Packets
Published on: February 6, 2014
Photonic compressive sampling of wideband sparse radio frequency signals with 1-bit quantization
Abstract:
Photonic compressive sampling (PCS) is an effective method to recover wideband sparse radio frequency (RF) signals. However, the noisy and high-loss photonic link leads to signal-to-noise ratio (SNR) degradation of the RF signal to be tested, which limits the recovery performance of the PCS system. In this paper, a random demodulator-based PCS system with 1-bit quantization is proposed. The system consists of a photonic mixer, a low-pass filter, a 1-bit analog-to-digital converter (ADC), and a digital signal processor (DSP). The 1-bit quantized result is used to recover the spectra of the wideband sparse RF signal with the binary iterative hard thresholding (BIHT) algorithm, which can alleviate the negative impact of the SNR degradation caused by the photonic link. A full theoretical framework of the PCS system with 1-bit quantization is given. Simulation results show that the PCS system with 1-bit quantization can provide better recovery performance than the traditional PCS system under low SNR and stringent bit budget.
Related Concept Videos
Upsampling
Bandpass Sampling
A bandpass signal has a spectrum with a lower frequency limit, denoted as ω1, and an upper frequency limit, denoted as ω2....
Aliasing
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original...
Sampling Continuous Time Signal
In the...
Reconstruction of Signal using Interpolation
Sampling Theorem

