Related Experiment Video

Updated: Jul 23, 2025

Fine-tuning the Size and Minimizing the Noise of Solid-state Nanopores
09:43

Fine-tuning the Size and Minimizing the Noise of Solid-state Nanopores

Published on: October 31, 2013

13.5K

Low-noise and high-speed trans-impedance amplifier for nanopore sensor

Shaoxi Fang1,2, Bohua Yin1,3, Wanyi Xie1,2

  • 1Chongqing Key Laboratory of Multi-scale Manufacturing Technology, Chongqing Institute of Green and Intelligent Technology, Chinese Academy of Sciences, Chongqing 400714, People's Republic of China.

The Review of Scientific Instruments
|July 13, 2023
PubMed

More Related Videos

Fabrication of Carbon Nanotube High-Frequency Nanoelectronic Biosensor for Sensing in High Ionic Strength Solutions12:20

Fabrication of Carbon Nanotube High-Frequency Nanoelectronic Biosensor for Sensing in High Ionic Strength Solutions

Published on: July 22, 2013

18.3K
Monitoring Protein Adsorption with Solid-state Nanopores08:51

Monitoring Protein Adsorption with Solid-state Nanopores

Published on: December 2, 2011

13.6K

Related Concept Videos

Small-Signal Analysis of MOSFET Amplifiers01:23

Small-Signal Analysis of MOSFET Amplifiers

In small-signal analysis, a MOSFET transistor amplifier acts as a linear amplifier when operating in its saturation region. The gate-to-source voltage (VGS) of the MOSFET is the sum of the DC biasing voltage and the small time-varying input signal. This combination sets up the operating point and modulates the drain current (ID) that flows from the drain to the source. When a small AC signal is superimposed on the DC bias voltage at the gate, the instantaneous drain current comprises three...
611
MOSFET Amplifiers01:17

MOSFET Amplifiers

The MOSFET, when operating in its active region, functions as a voltage-controlled current source. In this region, the gate-to-source voltage controls the drain current. This principle underlies the operation of the transconductance MOSFET amplifier. The output current is directed through a load resistor to convert this amplifier into a voltage amplifier. The output voltage is then obtained by subtracting the voltage drop across the load resistance from the supply voltage. This process results...
186