Preparation of MoS₂ Nanospheres using a Hydrothermal Method and Their Application as Ammonia Gas Sensors Based on...

An ammonia sensor based on a delay-line surface acoustic wave (SAW) device is developed in this study by coating the delay line area of the device with a nano-structured molybdenum disulfide (MoS₂) sensitive material. A SAW device of 122 MHz was designed and fabricated with a pair of interdigital transducers (IDTs) defined on a 128° y-cut LiNbO₃ substrate using photolithography technologies, and the aluminum IDT electrodes were deposited by a DC magnetron sputtering system. By adjusting the pH values of precursor solutions, molybdenum disulfide (MoS₂) nanospheres were prepared with various structures using a hydrothermal method. Finally, an NH₃ gas sensor with high sensitivity of 4878 Hz/ppm, operating at room temperature, was successfully obtained. The excellent sensitivity performance may be due to the efficient adsorption of NH₃ gas molecules on the surfaces of the nanoflower-like MoS₂, which has a larger specific surface area and provides more active sites, and results in a larger change in the resonant frequency of the device due to the mass loading effect.