³D-³D dentition superimposition for individual identification: A study of an Eastern Chinese population

Recently, 3D dental intraoral scanning technology has been developed rapidly and applied widely in everyday dental practice. Since 3D dental scanning could provide valuable personal information, it enabled researchers to develop novel procedures for individual identification through ³D-³D dentition superimposition. This study aimed to test the applicability of this method in an Eastern Chinese population and propose a threshold for personal identification. For this purpose, 40 volunteers were recruited, and the initial 80 (upper and lower) 3D intraoral scans (IOS) were collected. After one year, 80 IOS of these volunteers were repeatedly collected. In addition, the other 120 IOS of 60 patients were extracted from the database. The 3D models were trimmed, aligned, and superimposed via Geomagic Control X software, and then the root mean square (RMS) value of point-to-point distance between the two models was calculated. The superimposition of two IOS belonging to the same individual was considered as a match, and superimposition of two IOS belonging to different individuals was considered as a mismatch. Totally, superimpositions of 80 matches and 3120 mismatches were obtained. Intra- and inter-observer errors were assessed through the calculation of relative technical error of measurement (rTEM). Mann-Whitney U test verified possible statistically significant differences between matches and mismatches (P < 0.05). The rTEM of intra- and inter-observer repeatability analyses was lower than 4.7 %. The range of RMS value was 0.05-0.18 mm in matches and 0.72-2.28 mm in mismatches without overlapping. The percentage of accurate identification reached 100 % in blind test through an arbitrary RMS threshold of 0.45 mm. The results indicated that individual identification through the ³D-³D dentition superimposition was effective in Eastern Chinese population. Successful identification could be achieved with high probability when the RMS value of the point-to-point distance of two dentitions is <0.45 mm.