Related Experiment Video
Updated: May 23, 2026
Accuracy in Dental Medicine, A New Way to Measure Trueness and Precision
Published on: April 29, 2014
Accuracy and margin quality of advanced 3D printed monolithic zirconia crowns
Han Zhu1, Yi Zhou1, Jimin Jiang2
1Department of Periodontics, Stomatology Hospital, School of Stomatology, Zhejiang University School of Medicine, Zhejiang Provincial Clinical Research Center for Oral Diseases, Key Laboratory of Oral Biomedical Research of Zhejiang Province, Cancer Center of Zhejiang University, Engineering Research Center of Oral Biomaterials and Devices of Zhejiang Province, Hangzhou, PR China.
Statement Of Problem:
Nanoparticle jetting (NPJ) is a novel ceramic 3D printing technology with high printing accuracy. However, studies reporting the accuracy of zirconia crowns manufactured by NPJ and comparing them with conventional zirconia crowns are lacking.
Purpose:
The purpose of this in vitro study was to evaluate and compare the trueness, crown fit, and margin quality of monolithic zirconia crowns manufactured by NPJ with those milled by a computer numerical control system.
Material And Methods:
A gypsum left mandibular first molar was prepared and scanned with an intraoral scanner (TRIOS 4). Three types of monolithic crowns were manufactured through 3D printing and subtractive manufacturing (SM): NPJ (3D printing), VITA (milling), UPCERA (milling). The crowns were scanned, and the dimensional deviation (trueness) was evaluated and compared by using a software program. The triple scan method was used to measure crown fit and uniform index through precise alignment in the software program, and margin quality was also observed with an optical microscope. The data were analyzed with 1-way analysis of variance and the Tukey post hoc test (α=.05).
Results:
The NPJ group reported better trueness of all crown and axial surfaces compared with the other SM group (P<.001), but marginal trueness (P=.601), intaglio surface (P=.596), and occlusal surface (P=.641) were statistically similar compared with the Vita milled group. All 3 groups reported clinically acceptable crown fit and uniformity with statistically similar values (P>.05). The NPJ group had more crowns judged to have flawless margin quality compared with the milled groups.
Conclusions:
All 3 manufacturing methods can fabricate zirconia crowns with a clinically acceptable crown fit. The NPJ system could be used to manufacture monolithic zirconia crowns with better margin quality and proximal surface trueness than milled crowns.
Related Concept Videos
01:29Pulmonary Tuberculosis I
Causative Organism
The primary infectious agent causing tuberculosis is Mycobacterium tuberculosis, a slow-growing, acid-fast, aerobic rod that exhibits sensitivity to heat and ultraviolet light. Instances of Mycobacterium bovis and Mycobacterium avium contributing to the development of TB infection are rare.
Mode of...
01:28Pulmonary Tuberculosis II
Here is a detailed explanation of its pathophysiology:
Transmission: The process begins when a person inhales droplet nuclei containing M. tuberculosis. These are typically released into the air when an individual with pulmonary or...
01:31Pulmonary Tuberculosis III
The first classification is based on the development of the disease, and it includes the following categories:
01:26Pulmonary Tuberculosis IV
Several diagnostic approaches are used to detect TB. The conventional method is the Tuberculin Skin Test (TST), also known as the Mantoux test. However, this method has...
01:28Pulmonary Tuberculosis V
Latent tuberculosis infection occurs when TB bacteria are present in a person's body, but are not causing illness or symptoms. It is not contagious, and preventive treatment is crucial to avoid the progression...