Realization and Control of Robotic Injection Prototype With Instantaneous Remote Center of Motion Mechanism

Although there have been studies conducted on the instantaneous remote center of motion (RCM) mechanism, the general closed-loop control method has not been studied. Thus, this article fills that gap and employs the advantages of this mechanism to develop a novel injection system.

The injection prototype involves the instantaneous RCM mechanism, insertion unit and injection unit. The RCM system is investigated in the presence of time-varying axial stiffness of the screw drive and underactuated case. For safe interaction, compliance control is designed in the insertion system. The stability of all separate systems is investigated with the bounded parameter variation rate. The injection prototype and a robot end-effector were then combined to perform injection.

Our RCM prototype can achieve a large workspace, and its control effectiveness was verified by multiple frameworks and comparison with previous studies. Compliance-controlled insertion can achieve accurate depth regulation and zero-impedance control for manually operating the needle. With the help of three-dimensional reconstruction and hand/eye calibration, the manipulator can guide the injection prototype to a proper pose for injection of a face model.

The injection prototype was successfully designed. The effectiveness of the whole control system was verified by simulations and experiments. The particular robotic injection task can be performed by the prototype.

This article provides alternative schemes for developing an instantaneous RCM system, screw drive-based surgical tool, and robotic insertion with small needles.