Related Experiment Video

Updated: Aug 5, 2026

Computerized Dynamic Posturography for Postural Control Assessment in Patients with Intermittent Claudication
14:52

Computerized Dynamic Posturography for Postural Control Assessment in Patients with Intermittent Claudication

Published on: December 11, 2013

On the path length of postural sway

J Carroll

    Agressologie: Revue Internationale De Physio-Biologie Et De Pharmacologie Appliquees Aux Effets De L'Agression
    |May 1, 1986
    PubMed
    Summary

    No abstract available in PubMed .

    More Related Videos

    Sit-to-stand-and-walk from 120% Knee Height: A Novel Approach to Assess Dynamic Postural Control Independent of Lead-limb08:24

    Sit-to-stand-and-walk from 120% Knee Height: A Novel Approach to Assess Dynamic Postural Control Independent of Lead-limb

    Published on: August 30, 2016

    Experimental Methods to Study Human Postural Control08:12

    Experimental Methods to Study Human Postural Control

    Published on: September 11, 2019

    Related Concept Videos

    Gyroscope: Precession01:24

    Gyroscope: Precession

    Precession can be demonstrated effectively through a spinning top. If a spinning top is placed on a flat surface near the surface of the Earth at a vertical angle and is not spinning, it will fall over due to the force of gravity producing a torque acting on its center of mass. However, if the top is spinning on its axis, it precesses about the vertical direction, rather than topple over due to this torque. Precessional motion is a combination of a steady circular motion of the axis and the...
    Interference: Path Lengths01:10

    Interference: Path Lengths

    Consider two sources of sound, that may or may not be in phase, emitting waves at a single frequency, and consider the frequencies to be the same.
    Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
    Pole and System Stability01:24

    Pole and System Stability

    The transfer function is a fundamental concept representing the ratio of two polynomials. The numerator and denominator encapsulate the system's dynamics. The zeros and poles of this transfer function are critical in determining the system's behavior and stability.
    Simple poles are unique roots of the denominator polynomial. Each simple pole corresponds to a distinct solution to the system's characteristic equation, typically resulting in exponential decay terms in the system's response.