Related Experiment Video
Updated: Jul 24, 2026

Laboratory-determined Phosphorus Flux from Lake Sediments as a Measure of Internal Phosphorus Loading
Published on: March 6, 2014
Asian dust-deposition flux to the subarctic Pacific estimated using single quartz particles
Kana Nagashima1, Hajime Kawakami2, Koji Sugie3
1Research Institute for Global Change, Japan Agency for Marine-Earth Science and Technology, Yokosuka, Japan. nagashimak@jamstec.go.jp.
Abstract:
Iron availability limits marine ecosystem activities in large areas of the ocean. However, the sources and seasonal supply of iron, critically important for controlling surface ocean biogeochemistry and carbon cycling, are poorly understood. The western subarctic Pacific is a high-nutrient and low-chlorophyll region, and despite high concentrations of macronutrients, iron limits phytoplankton production in summer. Here, we determine the seasonal deposition flux of Asian dust using scanning electron microscope-cathodoluminescence analysis of single quartz particles derived from the western subarctic Pacific during 2003-2022 to trace provenance. We found a high (up to 6.9 mg m-2 day-1) deposition flux of Asian dust in May, June, and early July, with an annual average of 1.0 ± 0.2 mg m-2 day-1. The supply of dissolved-iron flux calculated from Asian dust was 0.9 ± 0.3 µg m-2 day-1 during the high productivity season (April-July), which is approximately half that from the deeper part of the ocean, calculated from vertical profiles of dissolved iron. Our study provides a reliable approach for estimating iron supply from dust to the surface ocean that may be critical for sustaining biological productivity under future ocean stratification, which suppresses nutrient supply from the subsurface ocean.
More Related Videos
07:32Monitoring Pedogenic Inorganic Carbon Accumulation Due to Weathering of Amended Silicate Minerals in Agricultural Soils.
Published on: June 4, 2021
09:41Isolation of Quartz Grains for Optically Stimulated Luminescence OSL Dating of Quaternary Sediments for Paleoenvironmental Research
Published on: August 2, 2021
Related Concept Videos
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
Quarrying of Stone
One common method involves using a diamond belt saw to cut large blocks from the quarry face. These blocks can be about 50 feet long and 12 feet high. After the initial vertical cut, drilling is performed at the base of the block.
Specific Gravity of Aggregate
Bulk or gross specific gravity is calculated by taking the ratio of the mass of aggregates in the saturated surface-dry state to the total volume that includes both the solids and the voids within the...
Bulk Density of Aggregate
Most natural mineral aggregates, like sand and gravel,...
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the aggregate...