Related Experiment Video
Updated: Jul 12, 2025
Accuracy in Dental Medicine, A New Way to Measure Trueness and Precision
Published on: April 29, 2014
Trueness and precision of complete arch dentate digital models produced by intraoral and desktop scanners: An ex-vivo
Janos Vag1, Clinton D Stevens2, Mohammed H Badahman3
1Department of Restorative Dentistry and Endodontics, Semmelweis University, Szentkirályi Street 47, Budapest 1088, Hungary.
Objectives:
The study aimed to compare the trueness and precision of five intraoral scanners (Emerald S, iTero Element 5D, Medit i700, Primescan, and Trios 4) and two indirect digitization techniques for both teeth and soft tissues on fresh mandibular and maxillary cadaver jaws.
Methods:
The maxilla and mandible of a fully dentate cadaver were scanned by the ATOS industrial scanner to create a master model. Then, the specimens were scanned eight times by each intraoral scanner (IOS). In addition, 8 polyvinylsiloxane (PVS) impressions were made and digitized with a Medit T710 desktop scanner. Stone models were then poured and again scanned with the desktop scanner. All IOS, PVS, and stone models were compared to the master model to calculate the mean absolute surface deviation for mandibular teeth, maxillary teeth, and palate.
Results:
For mandibular teeth, the PVS trueness was only significantly better than the Medit i700 (p < 0.001) and Primescan (p < 0.05). In maxillary teeth, the PVS trueness was significantly better than all IOSs (p < 0.05-0.001); the stone trueness was significantly better than Emerald S (p < 0.01), Medit i700 (p < 0.001) and Primescan (p < 0.01). In the palate, PVS and stone trueness were significantly lower than the iTero Element 5D (p < 0.01) and Trios 4 (p < p < 0.01). Stone trueness was significantly lower than the Medit i700 (p < 0.05). The precision in the palate was significantly lower for PVS and stone than for Emerald S (p < 0.01, p < 0.05), iTero Element 5D (p < 0.01, p < 0.01), Primescan (p < 0.001, p < 0.001), and Trios 4 (p < 0.001, p < 0.01). Significant differences in trueness between the IOSs were observed only in the mandibular teeth. The Medit i700 performed worse than Emerald S (p < 0.01) and iTero Element 5D (p < 0.01). For mandibular teeth, the Medit i700 was significantly more precise than Primescan (p < 0.01) and the Emerald S (p < 0.05). The Trios 4 was significantly less precise than Emerald S (p < 0.05). The precision of Medit i700 was significantly worse than iTero Element 5D (p < 0.01) for maxillary teeth, as well as the Primescan (p < 0.01) and Trios 4 (p < 0.05) for the palate.
Conclusions:
In general, indirectly digitized models from PVS impressions had higher trueness than IOS for maxillary teeth; precision between the two methods was similar. IOS was more accurate for palatal tissues. The differences in trueness and precision for mandibular teeth between the various techniques were negligible.
Clinical Significance:
All investigated IOSs and indirect digitization could be used for complete arch scanning in mandibular and maxillary dentate arches. However, direct optical digitization is preferable for the palate due to the low accuracy of physical impression techniques for soft tissues.
