Related Experiment Video
Updated: Jul 12, 2025

Mimicking and Measuring Occlusal Erosive Tooth Wear with the "Rub&Roll" and Non-contact Profilometry
Published on: February 2, 2018
Supplementation of Energy Drinks with Green Tea Extract: Effect on In Vitro Abrasive/Erosive Dentin Wear
Purpose:
To investigate the effect of the supplementation of energy drinks with green tea extract on abrasive and erosive dentin wear.
Materials And Methods:
Six groups, each comprising 15 bovine dentin samples, were prepared, yielding a total of 90 samples. Erosion was performed by immersing the samples in Red Bull and Red Bull light with and without green tea extract. Tap water with and without green tea extract was used as the control groups. The samples were subjected to abrasive/erosive cycling for five days. The following cycling was performed daily: toothbrush abrasion (20 brushstrokes; 2.5 N); eight erosive cycles (2 min storage in the respective solutions); in between the erosive cycles, storage in artificial saliva (60 min) and again toothbrush abrasion (20 brushstrokes; 2.5 N). During the night, samples were again stored in artificial saliva. Abrasive/erosive dentin wear was measured using a stylus profilometer (µm, accuracy = 40 nm). The measured dentin loss results from the vertical position shift on the y-axis from base to final profile after the wear process in 2D. Pairwise comparisons between the groups were carried out using Wilcoxon signed-rank test.
Results:
The following dentin wear (median [IQR]) was measured: Red Bull: 1.9 µm (0.5); Red Bull Light: 1.3 µm (0.3); Red Bull with green tea extract: 0.8 µm (0.3); Red Bull Light with green tea extract: 0.3 µm (0.5); Tap water with green tea extract: -0.2 µm (0.7); Tap water: -1.0 µm (1.2). The comparison of all tested groups to each other proved to be statistically significant (p < 0.05).
Conclusion:
The supplementation of energy drinks with green tea extract provide a protective effect against erosive/abrasive wear in vitro.
More Related Videos
05:30Roughness Impact of Piezoelectric Dental Scaler on Two Distinct Flowable Composite Filling Materials
Published on: January 10, 2025
07:42Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024