Related Experiment Video
Updated: Jul 11, 2025

Comparative Analysis of Lower Limb Kinematics between the Initial and Terminal Phase of 5km Treadmill Running
Published on: July 17, 2020
Effect of surface inclination on vertical loading rate and footstrike pattern in trail and road runners
Sharon Selvakumar1, Sin Ming Li2, Paul Fahey1,3
1School of Health Sciences, Western Sydney University, Campbelltown, New South Wales, Australia.
Abstract:
Trail runners have been reported to be more injury prone than road runners. Limited past studies have examined the difference in the running biomechanics between the two groups of runners. More importantly, the effect of surface inclination has not been fully investigated. Hence, this study examined the effect of surface inclination on running biomechanics in trail and road runners. Twenty trails and 20 road runners were recruited in this study. Trail runners appeared to be more experienced and had longer training distance per week (p < 0.001) compared to road runners. All participants ran at a self-selected pace on an instrumented treadmill in three inclination conditions (i.e., level, +10% uphill and -10% downhill) in a random order. Vertical average loading rate (VALR), vertical instantaneous loading rate (VILR) and footstrike angle (FSA) were measured using established methods. Trail runners experienced greater VILR (p = 0.039, Cohen's d = 2.9) with a greater FSA (p = 0.002, Cohen's d = 1.1) during downhill running than road runners. No significant differences in VALR, VILR and FSA were found between the two groups during level and uphill running. Our findings provide potential biomechanical rationale to explain a higher injury incidence among trail runners.
More Related Videos
Related Concept Videos
Impact: Problem Solving
By designating the launch point as the origin and utilizing kinematic equations, the vertical component of the projectile's velocity at the point of impact is...
Elevation of Intermediate Points on Vertical Curves
Work Done Over an Inclined Plane
The work done by gravity to move a rigid body, or the work done by an opposing force to move a rigid body against gravity, can be calculated using the center-of-mass framework. It is the line integral of the force of gravity over the path, considered positive if...
Beams with Unsymmetric Loadings
The first moment-area theorem determines the slope at any point on the beam. This theorem indicates that the change in slope between two points on a beam...
Influence of Earth's Curvature and Atmospheric Refraction on Leveling
Profile Leveling and Cross Sections

