Devonian-Carboniferous extension and Eurekan inversion along an inherited WNW-ESE-striking fault system in

Jean-Baptiste P Koehl1,2, Lis Allaart3,4, Riko Noormets3

  • 1Department of Earth and Planetary Sciences, McGill University, Montreal, Québec, H3A 0E8, Canada.

Open Research Europe
|November 16, 2023
PubMed

Related Concept Videos

The Fossil Record02:56

The Fossil Record

The fossil record documents only a small fraction of all organisms that have ever inhabited Earth. Fossilization is a rare process, and most organisms never become fossils. Moreover, the fossil record only exhibits fossils that have been discovered. Nevertheless, sedimentary rock fossils of long-lived, abundant, hard-bodied organisms dominate the fossil record. These fossils offer valuable information, such as an organism's physical form, behavior, and age. Studying the fossil record helps...
25.2K
Genetics of Speciation02:16

Genetics of Speciation

Speciation is the evolutionary process resulting in the formation of new, distinct species—groups of reproductively isolated populations.
19.3K
Divergence and Curl of Magnetic Field01:26

Divergence and Curl of Magnetic Field

The magnetic field due to a volume current distribution given by the Biot–Savart Law can be expressed as follows:
3.0K
Isothermal Processes01:21

Isothermal Processes

A thermodynamic process that occurs at constant temperature is called an isothermal process. Heat slowly flows into the system or out of the system to maintain thermal equilibrium. Processes involving phase changes like water evaporation into steam or freezing water into ice at a constant temperature are examples of Isothermal Processes.
An ideal gas can also undergo isothermal expansion or compression.
For example, consider 1 mole of an ideal gas inside an isolated cylinder at initial volume V...
3.7K
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
149
Elastic Strain Energy for Shearing Stresses01:20

Elastic Strain Energy for Shearing Stresses

As discussed in previous lessons, strain energy in a material is the energy stored when it is elastically deformed, a concept crucial in materials science and mechanical engineering. This energy results from the internal work done against the cohesive forces within the material. When a material undergoes shearing stress and corresponding shearing strain, the strain energy density, which is the energy stored per unit volume, is calculated. Within the elastic limit, where the stress is...
195