[Photodegradation of Plastic Blends in Seawater and Its Risk to the Marine Environment]

The production and use of plastic blends have been gradually increasing owing to their versatility and low cost. However, the photodegradation of plastic blends in seawater and the potential risk to the marine environment are still not well understood. In this study, plastic blends including polypropylene/thermoplastic starch blends(PP/TPS) and polylactic acid/poly(butylene adipate-co-terephthalate)/thermoplastic starch blends(PLA/PBAT/TPS) were investigated. The corresponding neat polymers, namely polypropylene(PP) and polylactic acid(PLA), were set as control groups. We investigated the formation of MPs and the changes in the physicochemical properties of plastic blends after photodegradation in seawater. The size distribution of MPs indicated that PP/TPS and PLA/PBAT/TPS were more likely to produce small-sized particles after photodegradation than PP and PLA owing to their poorer mechanical properties and lower resistance to UV irradiation. Noticeable surface morphology alterations, including cracks and wrinkles, were observed for plastic blends following photodegradation, whereas PP and PLA were relatively resistant. After photodegradation, the ATR-FTIR spectrum of PP/TPS and PLA/PBAT/TPS showed a significant decrease in the characteristic bands of thermoplastic starch(TPS), indicating the degradation of their starch fractions. The C 1s spectra demonstrated that aged plastic blends contained fewer -OH groups than the pristine MPs did, further confirming the photodegradation of TPS. These results indicate that PP/TPS and PLA/PBAT/TPS had a higher degree of photodegradation than PP and PLA and thereby generated more small-sized MPs. In summary, plastic blends may pose a higher risk to the marine environment than neat polymers, and caution should be taken in the production and use of plastic blends.