Improvement of the Genome Editing Tools Based on 5FC/5FU Counter Selection in Clostridium acetobutylicum

Several genetic tools have been developed for genome engineering in Clostridium acetobutylicum utilizing 5-fluorouracil (5FU) or 5-fluorocytosine (5FC) resistance as a selection method. In our group, a method based on the integration, by single crossing over, of a suicide plasmid (pCat-upp) followed by selection for the second crossing over using a counter-selectable marker (the upp gene and 5FU resistance) was recently developed for genome editing in C. acetobutylicum. This method allows genome modification without leaving any marker or scar in a strain of C. acetobutylicum that is ∆upp. Unfortunately, 5FU has strong mutagenic properties, inducing mutations in the strain's genome. After numerous applications of the pCat-upp/5FU system for genome modification in C. acetobutylicum, the CAB1060 mutant strain became entirely resistant to 5FU in the presence of the upp gene, resulting in failure when selecting on 5FU for the second crossing over. It was found that the potential repressor of the pyrimidine operon, PyrR, was mutated at position A115, leading to the 5FU resistance of the strain. To fix this problem, we created a corrective replicative plasmid expressing the pyrR gene, which was shown to restore the 5FU sensitivity of the strain. Furthermore, in order to avoid the occurrence of the problem observed with the CAB1060 strain, a preventive suicide plasmid, pCat-upp-pyrR*, was also developed, featuring the introduction of a synthetic codon-optimized pyrR gene, which was referred to as pyrR* with low nucleotide sequence homology to pyrR. Finally, to minimize the mutagenic effect of 5FU, we also improved the pCat-upp/5FU system by reducing the concentration of 5FU from 1 mM to 5 µM using a defined synthetic medium. The optimized system/conditions were used to successfully replace the ldh gene by the sadh-hydG operon to convert acetone into isopropanol.