Offsets in tide-gauge reference levels detected by satellite altimetry: ten case studies

Comparing measurements of absolute sea level by satellite altimetry and relative sea level by a tide gauge can reveal errors in either measurement system. Combining the measurements can determine vertical land motion (VLM) at the tide gauge. We here discuss ten case studies in which a tide gauge has likely experienced a small ($$ cm), discontinuous offset in the vertical, suggesting inadvertent loss of reference-level stability. Proper interpretation of offsets is helped if independent VLM measurements from nearby geodetic stations are available. In two cases, earthquake-induced VLM cannot be ruled out, although it appears unlikely. Offsets as small as 1-2 cm can be detected when both altimeter and tide gauge successfully observe the same ocean signal. This is most likely to occur for tide gauges located on small, open-ocean islands. Tide gauges near large land masses are typically more challenging owing to inadequacies of satellite altimetry near land and to differences between coastal and open-ocean sea levels. The case studies highlight the utility of satellite altimetry for tide-gauge quality control.

The online version contains supplementary material available at 10.1007/s00190-023-01800-7.