Longterm abrasive and erosive effect of whitening toothpaste on dentin surface

To evaluate the amount of dentin loss following immersion in or toothbrushing with whitening toothpaste (WT) containing hydrogen peroxide (HP) and citric acid (CA). Additionally, the amount of dentin loss after brushing with a WT alone or in combination with a conventional toothpaste was assessed, and the effects of HP and CA solutions on the dentin surface were investigated.

Bovine dentin specimens (n= 350) were randomly assigned to seven solutions of various compositions as toothpaste: The specimens assigned to each solution were then further divided into five treatment groups (n=10 each) : Group A = 1-hour immersion in each solution (ES); Group B = 10,000 brushing in ES; Group C = 1-hour immersion in ES + 10,000 brushing in ES; Group D = 1-hour immersion in ES + 10,000 brushing in reference slurry (RS); Group E = 10,000 brushing in ES + 10,000 brushing in RS. The amount and pattern of dentin loss were determined, and the surfaces were observed using noncontact profilometry.

The WT (pH 5.0) caused lower dentin loss than RS after a single brushing cycle; however, the extent of dentin loss after 1 hour of immersion in the WT was significantly greater than that in the RS. Among the specimens treated with WT, a significant difference in dentin loss was observed between Group C and Groups D and E (P< 0.05) but not between Groups D and E. The surfaces exposed to CAS1, CAPB, and WT exhibited U-shaped patterns of dentin loss after brushing or immersion, whereas a wedge-shaped pattern was observed in those that underwent brushing with the RS.

The effects (dentin abrasion) of a whitening toothpaste containing hydrogen peroxide and citric acid when used in combination with a conventional toothpaste were similar to those seen with the continuous use of a conventional toothpaste alone.