Optimization of the Shape of Hooked-End Steel Fiber Based on Pulling Out and Reinforcing Cementitious Composites

Efficient steel fiber-reinforced cementitious composites (SFRCC) should improve not only the ultimate tensile strength but also the residual tensile strength (post-cracking tensile strength) of the SFRCC matrix. The degradation of the post-cracking tensile strength of SFRCC depends on the pullout properties of the steel fibers from the cementitious matrix. When the straight steel fiber was pulled out from the matrix, the pullout resistance was affected by the actions of bonding and friction. After debonding, the load was transferred only by friction, and the pullout resistance decreased rapidly, resulting in a weak reinforcing effect. In addition, changing the fiber shape can effectively slow down the decreasing rate of the pullout resistance of the steel fibers, thus improving their reinforcing effects. In this study, the shape of the steel fibers was optimized to slow down the decrease in the pullout resistance of the steel fibers from the cementitious matrix, thus achieving better tensile properties of SFRCC. First, a calculation model for the steel fiber pullout resistance was established. On this basis, a method to optimize the shape of the steel fibers was proposed. Finally, the pulling out behavior of steel fibers with different end hook shapes was tested, and the influence of the steel fiber shape on the decreasing rate of the residual pullout resistance was analyzed. The results showed that the optimized hooked-end steel fibers had better pullout resistance than ordinary hooked end steel fibers of the same diameter, tensile strength, and matrix.