Related Experiment Video
Updated: Jul 5, 2025

Cooling Rate Dependent Ellipsometry Measurements to Determine the Dynamics of Thin Glassy Films
Published on: January 26, 2016
Kinetics of physical aging of a silicate glass following temperature up- and down-jumps
Ricardo F Lancelotti1,2, Edgar D Zanotto1, Sabyasachi Sen2
1Federal University of São Carlos, Graduate Program in Materials Science and Engineering, São Carlos, São Paulo 13565-905, Brazil.
Abstract:
In this article, we investigate the structural relaxation of lithium silicate glass during isothermal physical aging by monitoring the temporal evolution of its refractive index and enthalpy following relatively large (10-40 °C) up- and down-jumps in temperature. The Kohlrausch-Williams-Watts function aptly describes the up- and down-jump data when analyzed separately. For temperature down-jumps, the glass exhibits a typical stretched exponential kinetic behavior with the non-exponentiality parameter β < 1, whereas up-jumps show a compressed exponential behavior (β > 1). We analyzed these datasets using the non-exponential and non-linear Tool-Narayanaswamy-Moynihan (TNM) model, aiming to provide a comprehensive description of the primary or α-relaxation of the glass. This model described both up- and down-jump datasets using a single value of β ≤ 1. However, the standard TNM model exhibited a progressively reduced capacity to describe the data for larger temperature jumps, which is likely a manifestation of the temperature dependence of the non-exponentiality or non-linearity of the relaxation process. We hypothesize that the compressed exponential relaxation kinetics observed for temperature up-jumps stems from a nucleation-growth-percolation-based evolution on the dynamically mobile regions within the structure, leading to a self-acceleration of the dynamics. On the other hand, temperature down-jumps result in self-retardation, as the slow-relaxing denser regions percolate in the structure to give rise to a stretched exponential behavior.
More Related Videos
06:48Fluid-cell Raman Spectroscopy for operando Studies of Reaction and Transport Phenomena during Silicate Glass Corrosion
Published on: May 9, 2025
08:55Methods of Ex Situ and In Situ Investigations of Structural Transformations: The Case of Crystallization of Metallic Glasses
Published on: June 7, 2018
Related Concept Videos
Heating and Cooling Curves
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidΔT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance, q, and its...
Phase Transitions: Melting and Freezing
Temperature Dependence on Reaction Rate
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...
Third Law of Thermodynamics
Effect of Temperature Change on Reaction Rate
Atomic Spectroscopy: Effects of Temperature
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature...