Related Experiment Video
Updated: Jul 4, 2025

Real-Time Proxy-Control of Re-Parameterized Peripheral Signals using a Close-Loop Interface
Published on: May 8, 2021
Quantized-output-feedback practical prescribed-time design strategy for decentralized tracking of a class of
Sung Jin Yoo1, Bong Seok Park2
1School of Electrical and Electronics Engineering, Chung-Ang University, 84 Heukseok-Ro, Dongjak-Gu, Seoul, 06974, South Korea.
Abstract:
This paper proposes a decentralized practical prescribed-time (PT) tracking design using quantized output feedback (QOF) for uncertain interconnected lower-triangular systems with unknown time-delay interconnections. The local output signals are assumed to be only measured and quantized for the PT tracker design under a band-limited network. By employing a PT-dependent scaling function, a decentralized memoryless PT observer based on quantized local outputs is developed to estimate local unmeasurable state variables. Owing to output quantization, the available output feedback signals become discontinuous. As a result, the tracking error between the actual (i.e., unquantized) local output and the local desired signal cannot be utilized in the local virtual controller. To address this issue, a novel adaptive compensation mechanism is derived to design the local PT neural network tracking laws using only quantized local outputs and estimated states. The proposed PT tracking controller does not require information on the interconnected nonlinear functions and interaction delays. During the Lyapunov stability analysis, the boundary layer error decomposition approach is employed to address the issue of non-differentiability in the local virtual control laws. The proposed QOF control system achieves practical PT stability. It is shown that the settling time of local tracking errors can be predetermined, regardless of the design parameters and initial conditions. Finally, the proposed QOF decentralization strategy is supported with illustrative examples and a comparison to demonstrate its benefits.
Related Concept Videos
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be...
Linear Approximation in Time Domain
For a simple pendulum with a mass evenly distributed along its length and the center of mass located at half the pendulum's length,...
First Order Systems
When a first-order system is subjected to a unit-step input, its response is characterized by its transfer function. By applying the Laplace transform of the unit-step input to the transfer function, expanding the...
BIBO stability of continuous and discrete -time systems
To determine the BIBO stability, the convolution integral is utilized when a bounded continuous-time input is applied to a Linear Time-Invariant (LTI) system....
Linear Approximation in Frequency Domain
In contrast, nonlinear systems do not inherently possess these properties. However, for small deviations around an operating point, a nonlinear system can often be approximated as linear....

