Comparative studies on the anti-wear behavior of prismatic structures in different shell species

Prismatic structure is mainly located in the outer layer of mollusk shells. However, there is limited studies on their resistance to wear and the underlying mechanisms. The Vicker's hardness and sliding anti-wear properties of prismatic structures in four species of mollusk shells were systematically investigated for comparisons in the present work. The crystalline types, organic matrix content, structural arrangement, and dimension of prisms are varied among different species. The hardness and wear properties of prismatic structures are, in the first place, determined by the crystalline type, i.e., the aragonite prismatic structures are harder and more wear-resisting than the calcite types. The primary failure mechanism in the prismatic structure during wear tests is three-body abrasion. The volume of the crushed prism particles is directly related to the thickness of organic interface and the hardness of prisms. The organic sheaths form organic films during sliding, and thus lubricate the friction interface to some extent, but higher organic content leads to a wider interface, resulting in a higher plough force at the edge of prisms. A higher plough force gives rise to a severe three-body abrasion. Long and straight prisms perpendicular to the shell surface present a higher wear resistance. Too thin prisms cannot bear the plough force. Therefore, the anti-wear properties of prismatic structures are governed by the joint action of crystalline types, organic matrix, structural arrangement and dimension of basic building blocks.