Unsuspected Limitations of 3D Printed Model in Planning of Complex Aortic Aneurysm Endovascular Treatment

Static 3-dimensional (3D) printing became attractive for operative planning in cases that involve difficult anatomy. An interactive (low cost, fast) 3D print allowing deliberate surgical practice can be used to improve interventional simulation and planning.

Endovascular treatment of complex aortic aneurysms is technically challenging, especially in case of narrow aortic lumen or significant aortic angulation (hostile anatomy). The risk of complications such as graft kinking and target vessel occlusion is difficult to assess based solely on traditional software measuring methods and remain highly dependent on surgeon skills and expertise.

A patient with juxtarenal AAA with hostile anatomy had a 3-dimensional printed model constructed preoperatively according to computed tomography images. Endovascular graft implantation in the 3D printed aorta with a standard T-Branch Cook (Cook® Medical, Bloomington, IN, USA) was performed preoperatively in the simulation laboratory enabling optimized feasibility, surgical planning and intraoperative decision making.

The 3D printed aortic model proved to be radio-opaque and allowed simulation of branched endovascular aortic repair (BREVAR). The assessment of intervention feasibility, as well as optimal branch position and orientation was found to be useful for surgeon confidence and the actual intervention in the patient. There was a remarkable agreement between the 3D printed model and both CT and X-ray angiographic images. Although the technical success was achieved as planned, a previously deployed renal stent caused unexpected difficulty in advancing the renal stent, which was not observed in the 3D model simulation.

The 3D printed aortic models can be useful for determining feasibility, optimizing planning and intraoperative decision making in hostile anatomy improving the outcome. Despite already offering satisfying accuracy at present, further advancements could enhance the 3D model capability to replicate minor anatomical deformities and variations in tissue density.