Jove
Visualize
Contact Us
JoVE
x logofacebook logolinkedin logoyoutube logo
ABOUT JoVE
OverviewLeadershipBlogJoVE Help Center
AUTHORS
Publishing ProcessEditorial BoardScope & PoliciesPeer ReviewFAQSubmit
LIBRARIANS
TestimonialsSubscriptionsAccessResourcesLibrary Advisory BoardFAQ
RESEARCH
JoVE JournalMethods CollectionsJoVE Encyclopedia of ExperimentsArchive
EDUCATION
JoVE CoreJoVE BusinessJoVE Science EducationJoVE Lab ManualFaculty Resource CenterFaculty Site
Terms & Conditions of Use
Privacy Policy
Policies

Related Concept Videos

MOSFET Amplifiers01:17

MOSFET Amplifiers

156
The MOSFET, when operating in its active region, functions as a voltage-controlled current source. In this region, the gate-to-source voltage controls the drain current. This principle underlies the operation of the transconductance MOSFET amplifier. The output current is directed through a load resistor to convert this amplifier into a voltage amplifier. The output voltage is then obtained by subtracting the voltage drop across the load resistance from the supply voltage. This process results...
156
Small-Signal Analysis of MOSFET Amplifiers01:23

Small-Signal Analysis of MOSFET Amplifiers

557
In small-signal analysis, a MOSFET transistor amplifier acts as a linear amplifier when operating in its saturation region. The gate-to-source voltage (VGS) of the MOSFET is the sum of the DC biasing voltage and the small time-varying input signal. This combination sets up the operating point and modulates the drain current (ID) that flows from the drain to the source. When a small AC signal is superimposed on the DC bias voltage at the gate, the instantaneous drain current comprises three...
557

You might also read

Related Articles

Articles linked to this work by shared authors, journal, and citation graph.

Sort by
Same author

Erratum: Sub-50-femtosecond gain-managed amplified pulses enhance nonlinear ablation efficiency: publisher's note.

Biomedical optics express·2026
Same author

Single-mode nonlinear amplification of femtosecond pulses in a multimode-fiber regenerative amplifier.

Optics letters·2026
Same author

Erratum: Efficient, broadly-tunable, hollow-fiber source of megawatt pulses for multiphoton microscopy: erratum.

Biomedical optics express·2026
Same author

Sub-50-femtosecond gain-managed amplified pulses enhance nonlinear ablation efficiency.

Biomedical optics express·2026
Same author

Observation of stability of Gaussian beams and off-axis beam-cleaning in graded-index rods.

Optics express·2025
Same author

Multi-megawatt pulses from 1030 to 1300 nm based on soliton self-frequency shifting in a nitrogen-filled fiber: publisher's note.

Optics letters·2025
Same journal

Single-scan adaptive optics-enabled quantitative optical coherence tomography angiography for absolute three-dimensional retinal blood flow mapping.

Optica·2026
Same journal

Longitudinal, label-free, high-resolution imaging of glioblastoma spheroid response to therapy: a translational tool for preclinical evaluation of chemotherapy, radiation, and immunotherapy.

Optica·2026
Same journal

Enhanced penetration depth in optical coherence tomography and photoacoustic microscopy <i>in vivo</i> enabled by absorbing dye molecules.

Optica·2026
Same journal

Single-photon avalanche diode imaging sensor for subsurface fluorescence LiDAR.

Optica·2026
Same journal

Space-time inverse-scattering of translation-based motion.

Optica·2025
Same journal

Ultrasensitive Alzheimer's disease biomarker detection with nanopillar photonic crystal biosensors.

Optica·2025
See all related articles

Related Experiment Video

Updated: Jul 1, 2025

20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier
10:17

20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier

Published on: July 12, 2017

11.5K

Single-mode regenerative amplification in multimode fiber.

Henry Haig1, Nicholas Bender1, Yishai Eisenberg1

  • 1School of Applied and Engineering Physics, Cornell University, Ithaca, New York 14853, USA.

Optica
|March 4, 2024
PubMed
Summary
This summary is machine-generated.

Researchers achieved single-mode operation in multimode fiber lasers using regenerative amplification. This breakthrough enables high-energy, short-pulse fiber lasers with excellent beam quality and gain.

More Related Videos

Low-cost Custom Fabrication and Mode-locked Operation of an All-normal-dispersion Femtosecond Fiber Laser for Multiphoton Microscopy
08:48

Low-cost Custom Fabrication and Mode-locked Operation of an All-normal-dispersion Femtosecond Fiber Laser for Multiphoton Microscopy

Published on: November 22, 2019

7.5K
Writing Bragg Gratings in Multicore Fibers
08:48

Writing Bragg Gratings in Multicore Fibers

Published on: April 20, 2016

8.1K

Related Experiment Videos

Last Updated: Jul 1, 2025

20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier
10:17

20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier

Published on: July 12, 2017

11.5K
Low-cost Custom Fabrication and Mode-locked Operation of an All-normal-dispersion Femtosecond Fiber Laser for Multiphoton Microscopy
08:48

Low-cost Custom Fabrication and Mode-locked Operation of an All-normal-dispersion Femtosecond Fiber Laser for Multiphoton Microscopy

Published on: November 22, 2019

7.5K
Writing Bragg Gratings in Multicore Fibers
08:48

Writing Bragg Gratings in Multicore Fibers

Published on: April 20, 2016

8.1K

Area of Science:

  • Physics
  • Optical Engineering
  • Laser Technology

Background:

  • Ultrafast fiber lasers are crucial for scientific research and industrial applications.
  • Scaling peak power requires larger fiber mode areas, which typically leads to multimode operation.
  • Controlling multiple modes in large-core fibers is a significant challenge in laser design.

Purpose of the Study:

  • To demonstrate a novel technique for achieving single-mode operation in highly multimode fibers.
  • To develop a high-performance short-pulse fiber laser source.
  • To overcome the limitations of mode control in large-area fibers for high-power laser applications.

Main Methods:

  • Utilized regenerative amplification to control mode selection in a highly multimode fiber.
  • Employed a single amplification stage to generate short pulses.
  • Characterized the laser output for pulse energy, beam quality, and spectral properties.

Main Results:

  • Achieved single-mode operation from a highly multimode fiber.
  • Obtained high gain (>55 dB) with minimal amplified spontaneous emission.
  • Generated high pulse energy (>50 μJ) with good beam quality (M² ≤ 1.3).
  • Produced transform-limited 300 fs pulses in a single amplification stage.

Conclusions:

  • Regenerative amplification is an effective technique for single-mode operation in multimode fibers.
  • The developed fiber laser source offers an unprecedented combination of high gain, pulse energy, and beam quality.
  • This work opens avenues for scaling peak intensity and advancing short-pulse fiber laser technology.