Revealing the reason for enhanced CZTSSe device performance after Ag heavily doped into absorber surface

Ag-doping treatment is a popular method for enhancing the performance of kesterite-structured Cu2ZnSn(S,Se)4 (CZTSSe) solar cells. Among the various methods, incorporating a high concentration of Ag+ into an absorber surface has proven to be particularly effective. However, the exact mechanisms behind this improvement are still unclear. This study aims to investigate the key factors that improve device performance through simulation. Specifically, the influence of the change in the carrier density, CuZn antisite defects, interface defect density, and formation of an n-type AZTSSe surface after heavy surface Ag doping have been examined. The simulation results indicate that the formation of an n-type AZTSSe layer on an absorber surface can significantly improve the open circuit voltage (VOC) and overcome the efficiency saturation problem induced by severe interface recombination for CZTSSe devices with a negative conduction band offset (CBO), compared to other affecting factors. This is because the modified conduction band alignment and the realization of interface-type inversion reduce interface recombination and retard the Fermi level pinning. However, the formation of interface-type inversion does not significantly improve CZTSSe devices with a positive CBO, as these devices already have weaker interface recombination. This work implies that the formation of an n-type AZTSSe layer is crucial for further improving the performance of CZTSSe devices with a negative CBO and can pave the way for improving the performance of thin film solar cells with severe interface recombination.