Recycling thermally deactivated asbestos cement in mortar: A possible route towards a rapid conclusion of the "asbestos problem"
Related Experiment Video
Updated: Jul 1, 2025

Two-way Valorization of Blast Furnace Slag: Synthesis of Precipitated Calcium Carbonate and Zeolitic Heavy Metal Adsorbent
Published on: February 21, 2017
Giancarlo Capitani1, Michele Dalpiaz2, Fabrizio Vergani1
1Department of Earth and Environmental Sciences, University of Milan-Bicocca, Italy.
Abstract:
The "asbestos problem" arises from the fact that asbestos is still abundant in many buildings and represents a hazard for human health. Current strategies adopted by law aiming at mitigating this hazard are far from being ideal. A smarter solution would be an energy sustainable detoxification treatment followed by recycling. If adopted, it would preserve the environment from pollution, natural resources from depletion and human health from hazard. Asbestos-cement slates were thermally deactivated through a sustainable process and reused in mortar for plaster applications. We found that the addition up to 7 wt% of the deactivated product does not affect significantly the water demand; does not affect thixotropy, stickiness and spreadability of the plastic mixture; slightly increases the strength of the mortar; does not compromise mechanical properties after aging. Considering the huge amount of traditional mortar employed worldwide, a rapid end of the "asbestos problem" is envisaged.
More Related Videos
Related Concept Videos
Masonry in Cold and Hot Weather Conditions
Other key practices include keeping masonry units...
Mass Concreting
To reduce the risk of such cracking, the concrete mix may incorporate low-heat cement and pozzolans to reduce the temperature rise. Pre-cooled angular aggregates and water-reducing admixtures...
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...
Mortar Joint Deterioration in Masonry
The...
Strength and Heat of Hydration
The heat of hydration for each cement compound is significant; for instance, tricalcium aluminate (C3A) and...
Mortar

