Related Experiment Video
Updated: Jul 1, 2025

High-throughput, Microscale Protocol for the Analysis of Processing Parameters and Nutritional Qualities in Maize Zea mays L.
Published on: June 16, 2018
A preparation of debranched waxy maize starch derivatives: Effect of drying temperatures on crystallization and
Ai-Jun Xie1, Mo-Han Li2, Zhi-Wei Li3
1Department of Chemical and Biomolecular Engineering, National University of Singapore, 119077, Singapore; Department of Biotechnology, College of Life Sciences and Biotechnology, Korea University, Seoul 02841, South Korea.
Abstract:
The impact of recrystallization conditions and drying temperatures on the crystallization and digestibility of native waxy maize (Zea mays L.) starch (NWMS) was explored. This study involved subjecting NWMS to concurrent debranching and crystallization at 50 °C for up to 7 days. Samples were collected by oven-drying at 40, 60, and 80 °C for 24 h. This simultaneous debranching and crystallization process increased the resistant starch (RS) content by approximately 48 % compared to the native starch. The drying temperatures significantly influenced the RS content, with samples dried at 60 °C exhibiting the lowest digestibility. X-ray diffraction (XRD) analysis revealed that most crystals demonstrated a characteristic A-type arrangement. Debranching and crystallization processes enhanced the crystallinity of the samples. The specific crystal arrangement (A- or B-type) depended on the crystallization conditions. A 15 min heating of NWMS in a boiling water bath increased the digestible fraction to over 90 %, while the samples subjected to debranching and crystallization showed an increase to only about 45 %. A linear correlation between starch fractions and enthalpy was also observed.
More Related Videos
07:06Methods for the Self-integration of Megamolecular Biopolymers on the Drying Air-LC Interface
Published on: April 7, 2017
08:52Method to Produce Durable Pellets at Lower Energy Consumption Using High Moisture Corn Stover and a Corn Starch Binder in a Flat Die Pellet Mill
Published on: June 15, 2016