Zn-Based Alloys for Plain Bearings-Influence of Al and Cu Content on Mechanical Properties

In recent decades, the requirements for plain bearing materials have continually increased, especially with new applications such as wind turbines, which require larger bearings. These new applications have completely different property profiles compared with, for example, bearings in automotive construction. Larger bearings need high strength and wear resistance, which established bearing materials cannot fulfill. Therefore, new alloy systems are required. This publication focuses on the influence of alloy composition and test temperature on the mechanical properties of ZnAlCu alloys. Centrifugally cast specimens were produced for the fabrication of test specimens, which were used to determine the mechanical and tribological properties. Fracture surface and wear trace analysis with scanning electron and light microscopy were used to determine occurring failure and wear mechanisms and to analyze the influence of microstructure on failure. Depending on the composition of the ZnAlCu alloys, up to three times higher strengths can be achieved compared with the white metal alloy SnSb12Cu6ZnAg. Furthermore, all the alloys investigated show good wear properties. Up to 11 wt.% aluminum and 1.5 wt.% copper, a significant decrease in the wear coefficient was observed. Knowledge about the correlation between microstructure, properties, and failure mechanisms of ZnAlCu alloys can be used to produce bearing metal alloys suitable for a wide range of applications. Since the strength values lie between those of white metals and bronze, new fields of application can also be accessed.