Related Experiment Video
Updated: Jun 30, 2025

Sandy Soil Improvement through Microbially Induced Calcite Precipitation MICP by Immersion
Published on: September 12, 2019
Strength and microstructural properties of silt soil cured by lime-activated fly ash-GGBS under different curing
Shunmei Gong1, Songbao Feng2, Shiquan Wang2
1National Engineering Research Center of Coal Mine Water Hazard Controlling, School of Resources and Civil Engineering, Suzhou University, Suzhou, 234000, China. gsmmei@ahszu.edu.cn.
Abstract:
To reveal the mechanism of the influence of the curing temperature on the strength of lime activated fly ash-GGBS cured silt soil, the curing of dredged silt was carried out by using fly ash and GGBS as the curing agent and lime as the activator. Unconfined compressive strength (UCS) experiments were carried out, and the micro-analysis of the cured silt was carried out by experimental methods including scanning electron microscope (SEM) tests, X-ray diffraction (XRD), etc. to reveal the mechanism of the curing temperature on the dredged silt. According to the test results, the hydration reaction and pozzolanic reaction between lime-fly ash-GGBS and silt soil were promoted with the increase of the curing temperature. when the curing temperature of the sample reached 40 ℃, a large amount of gel products such as hydrated calcium aluminate (C-A-H) and hydrated calcium silicate (C-S-H) were generated, which enhanced the bonding force between soil particles and filled up the inter-particle pore space, thereby improving the UCS of the sample. The results of SEM confirmed that C-A-H and C-S-H were the main substances for the construction of cured silt skeleton. C-S-H and C-A-H were detected by XRD. The results of the study fill the gap in the effect of curing temperature on the direction of lime-activated fly ash-GGBS cured silt soil.
Related Concept Videos
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Curing of Concrete
Soundness of Cement
Fineness of Cement
Direct...
Pozzolans
Fly ash is...
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...

